spinner removal
- Roger King
- Posts: 4396
- Joined: Mon Mar 19, 2007 10:29 pm
- Location: St Ives, Cambs
Re: spinner removal
Yes, I'll bet they're MGB, you should be OK.
Re: spinner removal
Roger,
That's the way i'm leaning having just had the rear-diff done [well replaced with Quaife].
Your AC one's are they comparable with MG ones?.
That's the way i'm leaning having just had the rear-diff done [well replaced with Quaife].
Your AC one's are they comparable with MG ones?.
- Roger King
- Posts: 4396
- Joined: Mon Mar 19, 2007 10:29 pm
- Location: St Ives, Cambs
Re: spinner removal
They are the same. The IVA kit contains MGB Hex-nut spinners, which people replace with AC ones post-test.
Re: spinner removal
and where can one source the AC [2-ear] ones from?
- Roger King
- Posts: 4396
- Joined: Mon Mar 19, 2007 10:29 pm
- Location: St Ives, Cambs
Re: spinner removal
Hawk usually have them, probably the other usual suspects.
- StewbieC
- T289R Committee
- Posts: 1361
- Joined: Mon Oct 13, 2008 12:50 pm
- Location: out in the sticks, Shropshire
Re: spinner removal
I'm interested in the spinner removal socket for 2 eared spinners too please! (I've mailed Lionel)
Btw Spinners http://shop.mwsint.com/product_details.asp?id=76 You need them for each side
Btw Spinners http://shop.mwsint.com/product_details.asp?id=76 You need them for each side
________________________________________________
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..
Stu
Hawk 289, 66 Mustang Fastback with a 289 maximum smiles per mile..
Re: spinner removal
That's fantastic - thank you Roger and Stu.
Re: 3 eared wheel spinner tool
I've been looking for some time for a suitable fitting/removal tool for the 3 eared spinners securing the wire wheels on the splined hubs of my car. Thanks to the posts on this forum, I contacted Lionel Roberts who was most helpful and he offered to make a tool for me. I have sent him one of my spinners to work with, to make a suitable tool that will take the hefty torque needed for this type of fixing. Thanks again to T289R for the info, and look forward to reporting on the tool on receipt.
- amulheirn
- T289R Committee
- Posts: 1207
- Joined: Mon May 13, 2013 2:30 pm
- Location: Surrey/Hampshire
- Contact:
Re: spinner removal
Welcome to the forum driveav8! What kind of car do you have?
Re: spinner removal
My brother wanted to get me one of these for Christmas, but apparently the Wheelwidget email doesn't work. Anyone got another email address for Lionel?agnoraan wrote:Well, my "Wheel Widget" arrived the other day and it's a lovely piece of kit. Lionel did a fantastic job and it works really well. He did say that if it didn't fit, for me to send it back to him to modify it to work as it should. As this was the first that he's made one for the Trigo wheels we were expecting some possible teething troubles. The only thing that I did was to mill 4mm from the face that is nearest the whel, so that the tool could engage behind the spinner slightly more. I've spoken to Lionel abou this and he can modify any future ones accordingly. The best bit is the cost, at only £45.00 all in, it's easily worth that than struggling to hammer wheels off. He has said that he'd be more than pleased to make more for 289 Register members .
Nige
Kevin