I need to connect the outlet of my Filter King to the inlet of my Holley carburettor.
The Holley has a banjo on it with a hose barb, so it would accept a hose pushed on and held in place with a Jubilee clip.
The Filter King (FPRV8/NPT) just has a threaded hole. I think I know from the part number that this is a 1/8 NPT thread internally.
Not sure why, but no hose barbs were supplied for the Filter King. None is needed on the inlet side since Gerry's braided fuel line screws in via an adapter.
So I need one of these two solutions I think:
- A 1/8NPT to hose barb fitting on the outlet of the Filter King, plus some fuel hose and two Jubilee clips
- A custom hose that has 1/8NPT at one end, and a banjo at the other.
Just wondered what your thoughts were.
Cheers,
Andy