Any other SD1 parts required from donor....?

Technical Area for all the problems you have in the garage
Post Reply
Chris Pendry
T289R Member
T289R Member
Posts: 25
Joined: Fri Dec 06, 2019 10:03 am

Any other SD1 parts required from donor....?

Post by Chris Pendry »

Engine and gearbox extracted as of today and I’ve sold the rolling SD1 shell to an enthusiast so this will be going at the weekend
Before I let this go are there any other parts I should consider keeping/using from the donor for my Rover based Hawk 289

Gearbox crossmember ?
Propshaft ?
Radiator ?
Stay Bars for the engine mounts?
Brake servo ?
Clutch master cylinder ?
Wiper motor ?
Speedo Cable ?
Viscous Fan ?

I think the Calipers are 2 pot not 4 so will probably let these go

Any other advice appreciated

Chris
allan horsfall
Posts: 374
Joined: Sat Apr 03, 2010 4:05 pm

Re: Any other SD1 parts required from donor....?

Post by allan horsfall »

Hi Chris,

Maybe the 'coil', cant think of anything else offhand.

Regards
Chris Pendry
T289R Member
T289R Member
Posts: 25
Joined: Fri Dec 06, 2019 10:03 am

Re: Any other SD1 parts required from donor....?

Post by Chris Pendry »

Thanks Allan I’ve kept that
Do you know if I need the stay bars for the engine mounts that the SD1 had for use in the Hawk chassis?
Also are you able to mount a standard SD1 Radiator in the front (space?) or go Gerry’s ally Rad
CobStang
Posts: 320
Joined: Sat Dec 10, 2011 3:21 pm

Re: Any other SD1 parts required from donor....?

Post by CobStang »

Ignition ballast resistor on inner wing and the wiring harness to go with it.
Chris Pendry
T289R Member
T289R Member
Posts: 25
Joined: Fri Dec 06, 2019 10:03 am

Re: Any other SD1 parts required from donor....?

Post by Chris Pendry »

Got it - thankyou and the wiring
Post Reply