Wiper blade arms
-
- T289R Member
- Posts: 240
- Joined: Mon Dec 14, 2015 6:29 pm
- Location: West Sussex
Like
You liked this
Wiper blade arms
I have noticed that most Hawks have their wipers parked nicely parallel with the the lower edge of the windscreen. Many cobra replicas, including mine have the wipers at an angle when parked, wihch looks fairly amateur. Does anyone have a suitable part number for these better positioned wiper ams? thanks
Re: Wiper blade arms
Just bend the arm. Simples.
Cheers, Clive.
(If I'm not here I'm in my workshop or on the golf course!)
(If I'm not here I'm in my workshop or on the golf course!)
Re: Wiper blade arms
Tex Automotive, Arm:U70842, Wiper Blade:B05109
Karl
Karl
- StewbieC
- T289R Committee
- Posts: 1070
- Joined: Mon Oct 13, 2008 12:50 pm
- Location: out in the sticks, Shropshire
Like
You liked this
Re: Wiper blade arms
As Clive says, mine were at about 30 degrees before I adjusted them.
________________________________________________
Stu
Hawk 289, maximum smiles per mile..
Stu
Hawk 289, maximum smiles per mile..
-
- T289R Member
- Posts: 240
- Joined: Mon Dec 14, 2015 6:29 pm
- Location: West Sussex
Like
You liked this
Re: Wiper blade arms
thanks for the replies.
- so: place in vice and apply hammer, or is there a more delicate way to make the mod?
- so: place in vice and apply hammer, or is there a more delicate way to make the mod?
- clive
- T289R Member
- Posts: 2875
- Joined: Thu Mar 01, 2007 1:18 am
- Location: Perth
Like
You and 1 others liked this
Re: Wiper blade arms
Hold the end that the blade fits to in the vice and bend gently by hand.
Cheers, Clive.
(If I'm not here I'm in my workshop or on the golf course!)
(If I'm not here I'm in my workshop or on the golf course!)
-
- T289R Member
- Posts: 240
- Joined: Mon Dec 14, 2015 6:29 pm
- Location: West Sussex
Like
You liked this
Re: Wiper blade arms
- excellent - thanks, will give it a go.
-
- T289R Member
- Posts: 1152
- Joined: Wed Mar 05, 2014 9:05 am
- Location: Surrey
Like
You liked this
Re: Wiper blade arms
I don’t remember having to bend mine. Do you have the correct sweep of the blades. There are differing cams for the wiper motor that give differing sweeps.
Peter C
Peter C
Re: Wiper blade arms
Looking at your car Peter, it seems you might have had arms that were pre-bent. Mine were straight and just didn't look right when parked, therefore I bent mine to suit. (Perhaps they could do with being bent a little more)






Cheers, Clive.
(If I'm not here I'm in my workshop or on the golf course!)
(If I'm not here I'm in my workshop or on the golf course!)
-
- T289R Member
- Posts: 240
- Joined: Mon Dec 14, 2015 6:29 pm
- Location: West Sussex
Like
You liked this
Re: Wiper blade arms
Mine are kinked, but not enogh to lie correctly on the screen. The sweep is fine, once I changed the cam to park on the desired side.